Body trim question
D.R. THE PATHETIC DORK
Joined: Jun 2007
Posts: 30,871
From: West Virginia
RE: Body trim question
there is usually a stiff metal backing on which the double sided tape is stuck too..I remove the metal backing so the trim lays flat and clean the surface with wax and grease remover and I believe I bought a roll of 3m double sided tape 1/2 wide from the autobody paint store.. it was like 30 dollars for a roll[:@]
Thread Starter
1st Gear Member
Joined: Sep 2007
Posts: 126
From:
RE: Body trim question
ORIGINAL: mjr46
there is usually a stiff metal backing on which the double sided tape is stuck too..I remove the metal backing so the trim lays flat and clean the surface with wax and grease remover and I believe I bought a roll of 3m double sided tape 1/2 wide from the autobody paint store.. it was like 30 dollars for a roll[:@]
there is usually a stiff metal backing on which the double sided tape is stuck too..I remove the metal backing so the trim lays flat and clean the surface with wax and grease remover and I believe I bought a roll of 3m double sided tape 1/2 wide from the autobody paint store.. it was like 30 dollars for a roll[:@]
D.R. THE PATHETIC DORK
Joined: Jun 2007
Posts: 30,871
From: West Virginia
RE: Body trim question
I used the 30 dollar one cause it was 1/2 wide so I wouldn't have to double up on the thinner stuff and enough comes on the roll to do more than the complete car.. I still am using the same roll 5 years later on odds and ends little projects when they arise
Thread
Thread Starter
Forum
Replies
Last Post
Luke9222
4.6L General Discussion
19
Oct 22, 2015 11:55 PM
