Rust on shocktower
#1
Rust on shocktower
was getting ready to weld up a few holes today and while removing the wiring behind the fender I noticed alot of rust to the bottom of the shocktower on the passengers side of the car. I was thinking of hiting it with my snadblaster and getting rid of as much of the rust I can and than hiting it with primer and later on paint it when I go to paint my entire engine bay. The other thing is that K-member nut/bolt looks prety bad. I'd like to replace the K-member with a tubeular one but atm I dont have the cash to do that. Anyone have any sugestions on how I should go about it besides what I listed? Pic's below.
Thread
Thread Starter
Forum
Replies
Last Post
tj@steeda
Steeda Autosports
0
09-17-2015 07:57 PM