nightmare90gt

ok so i have to replace my rms again i know its the rear main seal so please dont ask to check the other gaskets they are all new including the pan.

so my question is which one do i use ford racing, napa teflon, mr. gasket i used a felpro teflon last time and it didnt last me 6 months any advice please

nightmare90gt

anyone

AdderMk2

check your PCV system. If its clogged, you will continue to blow out seals.

nightmare90gt

pcv valve, filter, and grommet are all brand new

TrimDrip

delete it and go to a different set-up

Also, i beleive Napa is a gates. Could be a National though.

nightmare90gt

delete what

Bubba 95SN

Did you put some thread sealant on all the flywheel bolts?

Venomantidote95

What are u using to install the seal if u gash crimp any part of it it'll leak! Lube the inner lip to ease install. Use a 3/8 or 1/2 extension to push it in not a screwdriver like I e seen and heard of! Make sure u install it in the right direction its a one way seal!

nightmare90gt

not sure cant remember and we used somthing that could go over the seal to put it in

TrimDrip

I try to use my fingertips when possible