I know everyone is prolly sick of people posting to ask if anyone could tell them where they are at as far as whp goes, but I have no access to a dyno, and I am extremely curious..
Its a 92 5.0 5spd, CAI, Shorty Headers, H-Pipe, Flowmaster exhaust.

If I had to guess I would want to say around 220whp.. But just wanted to see what anyone else thought.

 

220 is about 15 horse too high. I will bet you have around 205 RWH and 250 torque.

 

i dynoed today at 201/262 and i have basiclly the same thing as you. it was 93 degrees, so it may go a little higher on a cooler day.

 

wow i have the exact same setup as you minus the 5 speed.
and i didnt think i would be close to 200 whp yet.
but i guess if 89 notch got 201 then we must be close...

 

666 horse

 

unfortunatly not much more that what the factory gave you.... all that bolt on stuff works very well and big gains are seen with you add things like HCI. other than that, bolt ons should be used to make your HCI or other poweradders and work to its full potential. remember, all the power comes from spending money

 

I had mine dynoed and its completely stock engine with the flat tops for piston. I 'm got 190whp and 272 ft/lbs torque.