Marland people who built your roll bar or roll cage?
#1
Marland people who built your roll bar or roll cage?
So me and the owner of performance auto fab were having this discussion last nite.Where are all of you guys getting your roll bars and roll cages done in Md? And what kinda prices are you paying for them?Ive seen some pretty ugly ones lately and wonder how people could spend there hard earned money on some poor quality work?
#2
RE: Marland people who built your roll bar or roll cage?
noone, cause even though mine is fast enough for one, I refuse to put one in..I like the street car look besides I only car for one run below 11.50..if I were to put one it..it'd be the maximum motorsports bolt in one
#4
RE: Marland people who built your roll bar or roll cage?
^^^^yeah but I only race it at private mustang meets and they don't hammer to hard on that as long as your not way under..N/A I'll be safe the NO2 will put me way under but I doubt I'll even crack the bottle.. I may in the future put a bolt in one in but nothing permanant..gives away the element of suprise right now
#5
RE: Marland people who built your roll bar or roll cage?
I am not in MD but in WV I do my own stuff its not tiged just mig but it passes Tech without any problems I have done a few bars for people around here. I am looking to get a tig but most of the average racers don't have the cash to put up and do them there selves. When I was gone to have someone put mine in they wanted $1200 and that was back a few years I can weld so I just went and got a Mig welder for $1100 and did it my self. I am fortunate I can do all my own work but the machine work on my block. if I had to pay someone to do my work for me Icould not race.
Thread
Thread Starter
Forum
Replies
Last Post