Clearence issues
Thread Starter
Joined: Jun 2009
Posts: 1
From: Georgia
Clearence issues
So here the problem, got sweet deal on close out set of BBK shorty headers. They went on no problem and work great but, my steering bar link rubs on the drivers side head at the base of the collector. replaced the mounts, still rubs, tweaked the motor as safely forward as possible, still rubs, any one got an idea to fix this?
M.A.D. Motorsports
Joined: Jul 2006
Posts: 8,014
From: Indiana
Buy an aftermarket steering shaft.
http://www.latemodelrestoration.com/...0%201&comp=LRS
http://www.latemodelrestoration.com/...0%201&comp=LRS
Some people tend to have this problem and then some don't. You can also put a small ding where the shaft hits the header.
http://www.latemodelrestoration.com/...0%201&comp=LRS
http://www.latemodelrestoration.com/...0%201&comp=LRS
Some people tend to have this problem and then some don't. You can also put a small ding where the shaft hits the header.
Last edited by projectresto83; Jun 12, 2009 at 10:04 AM. Reason: Some people tend to have this problem and then some don't. You can also put a small ding where the shaft hits the header.
Thread
Thread Starter
Forum
Replies
Last Post
lincolnshibuya
V6 (1994-2004) Mustangs
9
Dec 8, 2015 04:37 PM
