95 Mustang GT Rolling Chassis - No Engine or Transmission
#1
95 Mustang GT Rolling Chassis - No Engine or Transmission
I have up for sale very nice rust free, clear titled Red 1995 Mustang GT. It has a nice black leather interior and is a factory 5.0 5 speed car. The previous owner had a T56 6 speed installed in it. It is currently setup for an AODE. The AODE shifter and computers are installed. The clutch pedal, manual brake pedal, and clutch cable are still installed in the chassis. I have the AODE transmission shifter cable and brake pedal. I have the original manual computer also. This GT can be converted back to a 5 speed or 6 speed very easily. The GT has never been wrecked and has all vin tages on the body panels.
This 95 GT has a completely built Superior rear end including Superior 31 spline axles, trak lok differential, 373 gears, trick flow aluminum differential cover, lake wood upper and lower control arms and an Eibach front and rear drag spring kit. There is also an air bag installed in the drivers side rear Eibach spring. The air bag fill cap is located in the rear bumper. This suspension has less then 1K on it. The rear tires are ET streets mounted on the factory wheels. The front wheels are rollers from a v6 car. Also has aftermarket quadrant and clutch cable still in it. The previous owner told me he upgraded the fuel pump. I don't know anything details about the pump.
The interior is very nice with no rips tears or holes in the leather seats. It has white faced gauges and doesn’t appear to be smoked in.
The only parts this GT needs are the motor, transmission, drive shaft, radiator, and exhaust. I do have a 1995 Mustang GT drive shaft from an AODE setup. This did not come with the rolling chassis and I will include it at no cost.
All of the wiring and ecu is intact. As stated above the two computer modules are in place for an AODE transmission. I will also include the manual computer at no additional cost.
This 1995 Mustang GT is 100% rust free and ready to be built. Can make into a nice daily driver or be that perfect drag car project.
The only flaw on the car is the paint has some fading from being a southern car. If you wet sanded and buffed it the finish should look much better. There are 2 or 3 very minor door dings. The type dings that aren’t very noticeable and wouldn’t show up in the pics. So minor paintless dent removal would easily take them out
Overall it’s a very nice project car that needs very little.
Clear clean title in hand ready to go.
I want $2,500.00. Car must be picked up. Car is located in East Lansdowne, PA, 19050 and can be seen upon request. Email me for pictures.
Please call me if you have any questions and/or concerns.
I also have a 347 stroker for sale with less then 3K on it since it was built. Email me for info and pictures. I do have that advertised in another Corral forum.
Thank You,
Dane R. Marley
danermarley@aol.com
610-896-0217 – home
610-299-6360 – cell
This 95 GT has a completely built Superior rear end including Superior 31 spline axles, trak lok differential, 373 gears, trick flow aluminum differential cover, lake wood upper and lower control arms and an Eibach front and rear drag spring kit. There is also an air bag installed in the drivers side rear Eibach spring. The air bag fill cap is located in the rear bumper. This suspension has less then 1K on it. The rear tires are ET streets mounted on the factory wheels. The front wheels are rollers from a v6 car. Also has aftermarket quadrant and clutch cable still in it. The previous owner told me he upgraded the fuel pump. I don't know anything details about the pump.
The interior is very nice with no rips tears or holes in the leather seats. It has white faced gauges and doesn’t appear to be smoked in.
The only parts this GT needs are the motor, transmission, drive shaft, radiator, and exhaust. I do have a 1995 Mustang GT drive shaft from an AODE setup. This did not come with the rolling chassis and I will include it at no cost.
All of the wiring and ecu is intact. As stated above the two computer modules are in place for an AODE transmission. I will also include the manual computer at no additional cost.
This 1995 Mustang GT is 100% rust free and ready to be built. Can make into a nice daily driver or be that perfect drag car project.
The only flaw on the car is the paint has some fading from being a southern car. If you wet sanded and buffed it the finish should look much better. There are 2 or 3 very minor door dings. The type dings that aren’t very noticeable and wouldn’t show up in the pics. So minor paintless dent removal would easily take them out
Overall it’s a very nice project car that needs very little.
Clear clean title in hand ready to go.
I want $2,500.00. Car must be picked up. Car is located in East Lansdowne, PA, 19050 and can be seen upon request. Email me for pictures.
Please call me if you have any questions and/or concerns.
I also have a 347 stroker for sale with less then 3K on it since it was built. Email me for info and pictures. I do have that advertised in another Corral forum.
Thank You,
Dane R. Marley
danermarley@aol.com
610-896-0217 – home
610-299-6360 – cell
Thread
Thread Starter
Forum
Replies
Last Post
inyadreems
Archive - Mustangs For Sale
2
08-21-2015 09:10 AM
Greyshot
4.6L (1996-2004 Modular) Mustang
2
08-15-2015 03:32 AM
Daleford
GT S197 General Discussion
0
08-10-2015 08:30 PM