hello all!
I'm brand new to this forum and looking for some technical help
i've recently just purchased a brand new 2010 mustang - grabber blue -
i also recently purchased a 15" kicker competition subwoofer with a 2000 watt legacy amp and a wiring kit. just wondering if somebody can direct me as to how to remove the radio surround/how to run wires and hook it all up?

 

Why not just tap a Line Output Converter off the rear deck speakers to run to the signal input of your amp? Other than that, you can find something that is keyed to the accessory/ignition in the fusebox so that your amp turns on and off with the key and run your power wire straight from the battery to your amp.

I think the fuses are called pigtail fuses and will allow you to replace an accessory/ignition on item in the fuse box and tie into the remote turn-on lead.

 

thanks old school!!
if i understood correctly, i should just be able to run a tap off of one of the rear speakers to the amp?

 

If your amp has high level inputs, you would be able to do it. I always recommend a Line Output Converter to change the speaker level outputs from the factory deck to RCAs. There is a PAC unit that has a gain control that I like to use: http://www.sonicelectronix.com/item_...AC+SNI-35.html

Of course, I must take this opportunity to warn you that Legacy amplifiers are very hit or miss and their customer service department is generally less than helpful.

 

gotta make an edit on the subwoofer there old school. it's a Pyramid PB1617X 2000 Watt 4 Channel Bridgeable Mosfet Amplifier. and its got low level inputs. can you explain to me step by step how to%2