Hello all, this place has helped me in the past and I'm back for more advice. I put a 68 collapseable column in my 67 and I'm having issues with the wiring. I replaced the turn signal switch but the new one has three extra wires, a red, brown, and yellow with black stripe, any suggestions? Also the rear turn lights work but both hood and front blink at the same time, I've got a gremlin right?

 

are these wires for the hood mounted turn signals?

 

This has been the best place for information I cannot find, please don't let me down y'all...

 

If I was there I could figure it out with a test light, but I don't think I could tell anyone how to actually do this...

Obviously the wire usage is different between the two columns, you need a schematic for the car and for the column harness to straighten things out.

I think the FAQ may have some schematics....

http://www.hammar.dyndns.org/~djhamm...ng/1968/E7.jpg

http://www.hammar.dyndns.org/~djhamm...7/67exter1.jpg

 

Thanx Bro...

I have the schematic book but have yet to find the answer to my question... I might have a monday friday part or I might just be thinking too much... at the end of the project and being held up by this one last thing...