I have had at least 10 people want to buy my console, build one or partner up on a business building them but I want to keep this a hobby. As soon as it becomes a business I would likely loose some interest. I am not sure if you were serious but just the thought was a nice compliment. Thank you.

 

do you think you could take and post some measurements if you have the time

 

I will but the car is at the body shop right now. They are going to install my power windows and will need the console to route the wiring. IIRC the console was 43" long and right at 8" wide. In the front it tucks under the dash of my 68 and extends into the rear seat area for two more cup holders that my daughters can use. The arm rest was about 11" tall from the lowest point to the top of the padded armrest. The angles of the front by the dash and the console are just what I thought looked good. I had to keep playing with the front section (where the gauges are) so that I left enough room for the shifter and boot. Does that give you enough info for a starting point or do you need more specific measurements?

 

You could use a cougar one just like the Shelby cars used.Theres not any newer car ones i know that will fit unless you want some cutting and making it fit.The one 68efivert made isn't that hard covering it and adding all the things on it he did took the most time i bet.