OnDemand 5 - Repair help for you.
#11
Juno, this is a great resource! Do you have anything on resetting a factory remote. The remote doesn't open or close the door locks of my 98 V6 'stang. Inside door lock buttons work fine so it's the remote. New batteries were installed. Factory remote hasn't been used in a long time and now being tried again. Owner's Guide says nothing about resetting. Thanks!
Let me know if that worked :]
#12
dang, Juno, that is great! I'm new to Mustangs, so forgive, but would you also have a diagram of the left rear quarter panel so I know where and what this programming connector looks like? it's dark now, so I'll tackle this in the light tomorrow. thanks again!
#14
And you don't wanna know how i get it =]
Its 60 Gigs database, 10 DVD's
#17
hey Juno, I got into the left rear quarter panel and as I feared, it's not real obvious. Here's a picture, can you point out the programming connector? or should I post a new topic? Thanks
http://farm4.static.flickr.com/3258/...87039c32_o.jpg
http://farm4.static.flickr.com/3258/...87039c32_o.jpg
Last edited by yeewiz; 02-03-2009 at 07:05 PM. Reason: html code didn't display picture
#18
STAND DOWN, PLEASE IGNORE PRIOR CRY FOR HELP. Juno, I actually used and was successful with search and found this post which had diagram. For others learning search, enter "programming connector". Here's the post:
https://mustangforums.com/forum/5-0-...ess-entry.html
Did the re-programming and my remote now works. Again, Juno, thanks for a great service to the Mustang community and helping me out!
For those looking at the picture, the connector is that wire with the connector lying on the floor in the middle of the picture.
https://mustangforums.com/forum/5-0-...ess-entry.html
Did the re-programming and my remote now works. Again, Juno, thanks for a great service to the Mustang community and helping me out!
For those looking at the picture, the connector is that wire with the connector lying on the floor in the middle of the picture.
Last edited by yeewiz; 02-03-2009 at 08:04 PM. Reason: adding comment re location in picture
#19
STAND DOWN, PLEASE IGNORE PRIOR CRY FOR HELP. Juno, I actually used and was successful with search and found this post which had diagram. For others learning search, enter "programming connector". Here's the post:
https://mustangforums.com/forum/5-0-...ess-entry.html
Did the re-programming and my remote now works. Again, Juno, thanks for a great service to the Mustang community and helping me out!
For those looking at the picture, the connector is that wire with the connector lying on the floor in the middle of the picture.
https://mustangforums.com/forum/5-0-...ess-entry.html
Did the re-programming and my remote now works. Again, Juno, thanks for a great service to the Mustang community and helping me out!
For those looking at the picture, the connector is that wire with the connector lying on the floor in the middle of the picture.
#20
ok I have a question I have a 95 gt 5.0 HO and I am looking to put a 94 to 97 5.8w roller motor in it can I use everything off my 5.0( intake set up, all front accessories and use the same oil pan and mounts just have to replace oil pump off the 5.8 to the 5.0 set up)