Hi All!!!

Only jambs and a few hours of sanding and masking stand between me and painting my converted GT to LX 88 Mustang!!!

Question I have is this...... without running inside fender/quarter and door moldings, where have others put the chip guard coating?

If I were to put the moldings, I think up to the bottom makes sense, but seeing they will not be put on, I was thinking maybe doing the rocker and angling up to the molding line on the fender and quarter; almost the same contour as the SVO Spats.

I could also just go straight across with the rocker line or I could use the molding line, but again, not sure how the molding line mask and chip guard would look.

Thanks everyone,

Steve C - RI