Hey guys,
I want to install a dual gauge pod on the pillar of my 95 3.8; water temp and oil pressure specifically.

Is this a tough job?

Am i limited in the type of gauge i can buy because of the v6 application?

i don't know a whole lot about this so any information you could give me would be greatly appreciated.

thanks,
matt

 

Shouldn't be hard seeing as how you should already have though gauges stock. Just tap your wire of the stock sensors.

 

thanks,

how about oil temp?

 

Not sure I'd have to look at my Hayne's manual. I think it might come off the same sensor as the oil pressure gauge, but don't quote me on that.

 

wouldn't you want to actually put the sensors in yourself or do you just need a neew gauge to read it persicly

 

this isnt an answer to your question, but before you get the A-Pillar gauge pod, i think these 2 guage pods look better and are alot more unique. more people have the a-pillar pods than they do these.