Hello,

So i will admit this is for my dads chevy 383 were building. But this can easily tie into ford heads as well.

We bought brodix IK 200cc heads and are having a rough time getting the edelbrock RPM intake to seal around the large ports.

I read on a few websites that the brodix heads have issues with matching up with lower intakes due to the large port size.

What intakes do you recommend that will give me a better fit / a better seal around the ports.

Thanks!

 

I have read that the RPM Air Gap is the best intake for the job.

But how much of a difference will i see over my current RPM performer? Is there that big of a difference in the ports??