kenholley2122

I was just woundering what everyones opion on wether to forge my block or buy one already forged. i have an 06 mustang gt with paxton 2200. any place or web sites to go please let me know.

hammeron

surprisingly, i may be asking this very same question, some day....

not sure what you should do, there are too many unknown variables.

01Steed

Personally, I'd go the already assembled route. Just easier that way.

Dex

you dont need to change the block but if you do i would buy another block. that way you can do an engine swap and not worry about taking apart the stock engine

baha

Since I'm going turbo in the near future I thought about it just like you, researched it, and decided to just forge the internals. It's been said the stock aluminum block with forged internals can withstand about 700rwhp. Plus the aluminum block is lighter and better in dealing with excessive heat.
BTW remember to lower your compression ratio (8:1-8.5:1).

And ooh...almost forgot...check out these links:

www.dssracing.com
www.seanhylandmotorsport.com
www.livernoismotorsports.com

jdback19

SHM in da hizzi!

ModernMuscle

I say go pre-assembled...just sell the other one! lol, make some money back.

kenholley2122

what SHM block did you get.