got a dyno done today with tune
#1
got a dyno done today with tune
Hey guys my mods are as follows..
C&L intake
Pypes O/R H-pipe
Steeda Delete Plates
FRPP Stingers
Dyno tune
Final numbers 298rwhp, 317 lb-ft I'll get the graph up after I get a scanner and compare before and after the O/R H-pipe and delete plates. My numbers before the O/R H-pipe and delete plates were 288rwhp, 305 lb-ft. I haven't noticed any loss in the lower RPMs because of the deletes. There is a definite seat of the pants difference after these mods along with better throttle response.
C&L intake
Pypes O/R H-pipe
Steeda Delete Plates
FRPP Stingers
Dyno tune
Final numbers 298rwhp, 317 lb-ft I'll get the graph up after I get a scanner and compare before and after the O/R H-pipe and delete plates. My numbers before the O/R H-pipe and delete plates were 288rwhp, 305 lb-ft. I haven't noticed any loss in the lower RPMs because of the deletes. There is a definite seat of the pants difference after these mods along with better throttle response.
#4
RE: got a dyno done today with tune
91 octane dyno tune. It was about 75 degrees out and overcast 1200 ft elevation.
ORIGINAL: BillyBobJoe
+1
was it on 87 octane? really hot? or just canned tunes on a dyno?
+1
was it on 87 octane? really hot? or just canned tunes on a dyno?
Thread
Thread Starter
Forum
Replies
Last Post
MustangForums Editor
Street/Strip
5
09-08-2015 06:25 PM