3.5" pulley on Gen 1 Whipple?
07-21-2008, 12:58 PM
#11
4th Gear Member
Join Date: Jul 2007
Location:
Posts: 1,062
RE: 3.5" pulley on Gen 1 Whipple?
You should FORGE!!
298 stroker with some minor head work and a 3.0" pulley made 507rwhp last week. (and it was HOT and HUMID during the dyno)
Run the 3.5" pulley and you will have no problems.
298 stroker with some minor head work and a 3.0" pulley made 507rwhp last week. (and it was HOT and HUMID during the dyno)
Run the 3.5" pulley and you will have no problems.
07-21-2008, 02:06 PM
#12
5th Gear Member
Thread Starter
Join Date: Jun 2007
Location: Orlando, FL
Posts: 2,276
RE: 3.5" pulley on Gen 1 Whipple?
I want too, but I also like being married 
I think I will trade for the 3.5" pulley and just hold onto it. If my car is underperforming slightly, I can swap it out for 1 extra psi.
Any input on the Cams?
I think I will trade for the 3.5" pulley and just hold onto it. If my car is underperforming slightly, I can swap it out for 1 extra psi.
Any input on the Cams?
Thread
Thread Starter
Forum
Replies
Last Post
Boostaddict
Lethal Performance
2
09-08-2015 09:56 PM
