FRPP CAMS will be installed 3/23 - Will include dyno sheet
#141
Get these! Mac LT's, they are cheap(for headers) And i've never heard anything about fitment issues(doesn't mean their aren't any tho).
http://www.brenspeed.com/20546.html
I'd be willing to bet you pick up at LEAST 20whp with the addition of headers.
http://www.brenspeed.com/20546.html
I'd be willing to bet you pick up at LEAST 20whp with the addition of headers.
Last edited by acarzt; 05-06-2009 at 11:57 AM.
#142
I'm aware of this. I also know the equations for HP, (Torque*RPM)/5252. ANYWAY, i know this isn't the same cam... but it is for comparison. Typically cams continue to make HP all the way to redline. His levels off and platues which means there is a bottleneck somewhere. Looking at his A/F he runs the SLIGHTEST bit rich at the very end. I bet if that last bit of RPM was leaned out he would gain a couple horses. But I think his exhaust isn't able to flow enough air to make the power up top.
here is the only Cam dyno I could find right now to compare... he has full exhaust and comp cams.
https://mustangforums.com/forum/6074768-post55.html
here is the only Cam dyno I could find right now to compare... he has full exhaust and comp cams.
https://mustangforums.com/forum/6074768-post55.html
Thread
Thread Starter
Forum
Replies
Last Post