boost-a-pump install
#1
boost-a-pump install
So in the directions for the Saleen stage 3 kit I am installing the Brenspeed wiring diagram contradicts the KB one. The KB directions are very specific about using the fused connection to the plug side of the wire you cut while the Brenspeed diagram has you use the fused end on the pump side of the wire.
Any advice?
Any advice?
#3
use the directions from brenspeed. this way does away with any delays in the BAP and shaves quite a bit of time off the install. I just did mine the brenspeed way and it took about 30 minutes total. No problems either.
#6
i sure dont man. I actually just sold that tuner on ebay about a week ago. sorry bud. i think you can call diablo and have them email you the canned tune to make it drive decent enough though.
Thread
Thread Starter
Forum
Replies
Last Post
tj@steeda
Steeda Autosports
0
09-10-2015 08:39 PM
06, 2005, boost, brenspeed, diagram, gt, hard, install, installation, installing, instructions, mustang, procharger, pump, wiring