Module reprogramming with IDS
#1
Module reprogramming with IDS
Hi,
I want to change some as built code for the ACM (basic to shaker 500 upgrade). When I open the Module programming option, a new set of option is offered : Module reprogramming & Programmable Module installation. I tried to use the first option but there is only the module APIM being displayed. The second option, does not allow me to change the code.
Is there a way to change only specific as built code for ACM ?
thanks,
Robert
I want to change some as built code for the ACM (basic to shaker 500 upgrade). When I open the Module programming option, a new set of option is offered : Module reprogramming & Programmable Module installation. I tried to use the first option but there is only the module APIM being displayed. The second option, does not allow me to change the code.
Is there a way to change only specific as built code for ACM ?
thanks,
Robert
Thread
Thread Starter
Forum
Replies
Last Post
LivingInThePast
Classic Mustangs (Tech)
2
09-16-2015 12:20 PM