well yesterday i decided to put on the bassani catted x ive been waiting to put on.
so i unbolt the stock h pipe and during the process a header stud snapped inside the header.
i tried drilling it out and using an easy out and nothings working. tried heating it up with a torch and still nothing.
any suggestions???

 

If you get a high quality bit and a good easeout you can get it. The only other option I can think of is pulling the manifold off.

 

Like the prior poster said, you might have to pull the header out, much easier to work at it there... Otherwise, drill and tap it where it sits...

 

This is the same exact thread that was in the 4.6 section. Whats up with that.

 

I agree, pulling the headers off is the easiest and fastest way to get it.

__________________
hella lights

 

i fixed it

 

you da man!