I am replacing the Shaker500 with an Eonon Android 71 Radio

I have the harness adapters, but the 8-pin isn't wired like the pin-out shows
at the radio side.



J4 Adapter has two RCA connectors wired, and two blue wires with white stripes:
8 65 / * **
4 21 / * **

8 and 4 have blue wires with white stripe, yet 8 says no connection.
7 and 3 has no pins there.

1 and 5 have RCA plugs with the L/R + wires, while 6 and 2 have their grounds, yet
Yet, 5 and 6 say no connection.

My 16 pin has two wires at 15 and 16, I think they're for the module.
Nothing else is in that harness.

My 24 pin has wires left over, and the colors are not on the instructions...
Blue with white stripe, and a solid blue. They are not listed in the
booklet with the wire colors and what they're for.

I got it all wired up otherwise.

 

Got it, that diagram must be wrong, because it's all working.


USBx2 And HDMI In:

OH, and I found the cover plate, was wedged between the hump and console side.

 

Also, the sound is much more crisp, bass tones are deeper, heavier, and have
way more thud than the Shaker did. This unit is like night and day, this one being
DAY. Has more volume too, is almost twice as loud as the shaker, so I will need to
upgrade the door and deck speakers. Thinking of going with Kicker...