possible map sensor issue?
#1
possible map sensor issue?
Ok so i have a 86 5.0 i just got done putting ported e7 heads on, a cobra upper and lower intake, and an x-303 cam in it. When the map vacuum line is on the idle shoots way up to about 2500 but doesnt miss or anything. When i take the vacuum line off it idles back down but starts running rich and misses bad. Is there anyway to fix the sensor for the cam? Is there anything i can do? The tps sensor is also on .9, tomorrow i need to make the holes bigger so i can adjust it more closer to .97. The lobe separation angle on the cam also is 112. Thanks for any info.
#2
it'll never run right with that cam on speed density.......requires mass air if you don't already have it converted.....if converted no line should be hooked to map...map becomes bap...........check for vac leaks
Thread
Thread Starter
Forum
Replies
Last Post
yourmom6990
Archive - Parts For Sale
2
09-14-2015 10:52 PM
TfcCDR
V6 (1994-2004) Mustangs
1
09-14-2015 12:08 PM
Boostaddict
Lethal Performance
2
09-08-2015 09:56 PM