HP/TQ Estimate
#1
HP/TQ Estimate
I was just wondering what rwhp and rwtq you guys think my car is making with the following...
2.25" divorced dual exhaust with Flowmaster 40's
XCal3 91 octane tune
42% UDP set
4.10's
Aluminum drive shaft (waiting for install)
Windstar intake (waiting for install)
2.25" divorced dual exhaust with Flowmaster 40's
XCal3 91 octane tune
42% UDP set
4.10's
Aluminum drive shaft (waiting for install)
Windstar intake (waiting for install)
#2
The exhaust and UDP is minimal, maybe 5 rwhp together. The 4.10's= no gain but a nice kick in the butt is always nice. The tune might get 10 rwhp....maybe.
Not sure bout the last two, i thought the windstar intake would get like 20 rwhp, not sure bout the driveshaft.
Anyways....this is all ricer math So the only way to tell is to get it all done
Not sure bout the last two, i thought the windstar intake would get like 20 rwhp, not sure bout the driveshaft.
Anyways....this is all ricer math So the only way to tell is to get it all done
#6
Ha ha seems like everybody has a different estimate. I'm going to throw it on a dyno but not yet. I'll probably wait until October to do it cause money is tight right now and I still need to do some installs before the car is complete.
#7
I'd guestimate near 180 rhwp and just over 200 rwtq.
Thread
Thread Starter
Forum
Replies
Last Post