V6 S197 General Discussion This section is for technical discussions pertaining specifically to the V6 variation of the 2005 and newer Ford Mustang.

"DTE FLI DATA ERR" message

Thread Tools
 
Search this Thread
 
Old Oct 19, 2007 | 08:41 PM
  #1  
cherrycandy001's Avatar
cherrycandy001
Thread Starter
 
Joined: Oct 2007
Posts: 29
From: Texas
Default "DTE FLI DATA ERR" message

Hello to all of you...
for those of you who read my other post about my gas tank issues...
This morning I was able to "fool" the nozzle in order to get a full tank
of Gas . After that I took my car to Midas where they ran an
engine scan because my "check engine" light came on...and so did the
"DTE FLI DATA ERR" so they managed to clear the message....
and it was gone right after that but then it came back on...
Any advice?

Old Oct 19, 2007 | 08:52 PM
  #2  
wolfey2k's Avatar
wolfey2k
4th Gear Member
 
Joined: Nov 2006
Posts: 1,199
From: State Of Confusion
Default RE: "DTE FLI DATA ERR" message

I believe that error comes up when I am re-programming my pony's 'puter.
While it's being accessed, downloaded from and uploaded to, that error shows up.
I don't have the foggiest wtf it means though. Maybe communications error? Or perhaps it means the ECU has spit dummy.
Wolfey2k
Old Oct 20, 2007 | 07:44 AM
  #3  
Wickerbill's Avatar
Wickerbill
3rd Gear Member
 
Joined: Jul 2007
Posts: 536
From:
Default RE: "DTE FLI DATA ERR" message

DTE FLI DATA ERR
Distance To Empty Fuel Level Indicator Error


You have a bad sending unit my friend. You can clear the code but it will always come back, take it to the stealership and get them to check the fuel pump sending unit.
Old Oct 20, 2007 | 09:39 AM
  #4  
157dB's Avatar
157dB
Cut & Paste Expert
 
Joined: May 2007
Posts: 13,322
From: NW Arkansas
Default RE: "DTE FLI DATA ERR" message

ORIGINAL: Wickerbill

DTE FLI DATA ERR
Distance To Empty Fuel Level Indicator Error


You have a bad sending unit my friend. You can clear the code but it will always come back, take it to the stealership and get them to check the fuel pump sending unit.

BINGO
+1
stealership time before the warranty runs out [:@]
Old Oct 20, 2007 | 01:54 PM
  #5  
cherrycandy001's Avatar
cherrycandy001
Thread Starter
 
Joined: Oct 2007
Posts: 29
From: Texas
Default RE: "DTE FLI DATA ERR" message

I dont have the warranty anymore...
it came as is and already has more than 36,000 miles on it.
My new warranty will kick in in about 850 miles..
so question is...


me having a bad sending unit...does that damage the car?
Old Oct 20, 2007 | 02:13 PM
  #6  
Wickerbill's Avatar
Wickerbill
3rd Gear Member
 
Joined: Jul 2007
Posts: 536
From:
Default RE: "DTE FLI DATA ERR" message

Depending on what the exact problem is. It doesnt neccessarily mean the sending unit is bad, maybe there is a spike in current caused by something else thats making the sending unit read bad.Maybe, and most likely, there is just a bad ground somewhere.All we can do here is speculate without having the car and running diagnostic scans. I would suggest getting it checked out asap. I wouldnt want to get stranded somewhere late at night because you ran out of gas and the gauge read wrong.
Old Jul 2, 2009 | 06:47 PM
  #7  
fklaszus's Avatar
fklaszus
 
Joined: Jul 2009
Posts: 1
From: Alberta
Default

Had the same problem, took it to a dealership and they informed me that BOTH fuel pumps were defective and that they would have to be replaced...to the tune of $1200! Took car back, pulled out both fuel pumps and cleaned the circuit boards on the sending unit with 600 grit sandpaper, put it back together and have not had any problems with it since. Cost me 1 hour of my time and $25 for a Haynes manual to help out with pulling the fuel pump out. Very unimpressed with the dealership obviously. There is a replacement sending unit available for approx $50 from the dealerships as well.
Old Jul 5, 2009 | 03:09 PM
  #8  
mrfish's Avatar
mrfish
 
Joined: Feb 2009
Posts: 6
From: Ca
Default Easy Fix

I just fixed this very same problem 3 days ago. The parts cost $140 from the dealer and took about 1 hour to fix. TSB 06-10-13 part#s 7R3Z-9A299-C Fuel Level Sensor 7R3Z-9275-C Sender Assy - Fuel Tank (Sender
card on the Fuel Pump Module) You also need new gaskets.

It was way easier to replace than I thought.
Old Jul 6, 2009 | 12:01 PM
  #9  
Sancho805's Avatar
Sancho805
5th Gear Member
 
Joined: Oct 2005
Posts: 3,678
From: Southern California
Default

did either of you have an aftermarket ipod adapter installed?
Old Jul 6, 2009 | 12:37 PM
  #10  
bdickens63's Avatar
bdickens63
 
Joined: Jul 2009
Posts: 2
From: Kentucky
Default Ipod Harness

I have the same issue and an aftermarket ipod harness. Do you have any info?



All times are GMT -5. The time now is 04:39 PM.