Newwt

If the fronts dont fit would modifications need to be taken place, maybe fender roll and spacers?

Jazzer The Cat

Spacers will make an issue of such a wheel worse on an S197

The SN95 wheels are about 5/8" more positive off-set than those meant for your model I know a 9.5" wheel is OEM on the Shelby, but runs a 255 tire. I know a 315 on a 10.5" wheel will fit, with the correct off-set, but requires the fender liner to be removed.

Do some searching around, but can tell you that a 10" wheel with say a 285 is gonna be a tight fit.

Jazzer

LilRoush

Are you wanting 18x10 with 285 on the front of an '01 Cobra or '01 Cobra replicas in 18x10 on your 2012???

Luke@tirerack

a 10" width is a bit much for the front but, you can easily run 275/40-17 on the Front & Rear using a 17x9with an offset in the 24-28 range

Timspony

I wouldn't go any bigger then a 275 (with a 9" wheel) on the fronts on any 2001 Cobra!! ...Out back, I'd go with a 305 with a 10" wheel on 18's outback!!

Jazzer The Cat

Little confused, as your avi says you have a '12 Stang, where the question says '01. To be clear, I figure you are NOT asking about a set of 18"x10" '01 Cobra wheels on your '12.

As Tim said, you are not going to properly fit such a wheel/tire up front on an '01 Stang... well, at least not on your current suspension Best to stick with a 275 max on 9" wheel, but recommend a 265 as a better fit.

Jazzer