4.6 4 valve?
5th Gear Member
Joined: Aug 2006
Posts: 2,127
From: Los Angeles Ca
RE: 4.6 4 valve?
ORIGINAL: marcuskeeler
OK, to take this further..... (The thread, not the flaming)
How much work would it be to take a crate 32 valve 2002/3/4 Cobra motor with ancilleries (I've seen them for sale) and drop it into an 05/6/7 ?
It's essentially wiring harness and OBC right [?] This is a mod I've been seriously considering given that the 32 valve is such a superior motor in every way.
OK, to take this further..... (The thread, not the flaming)
How much work would it be to take a crate 32 valve 2002/3/4 Cobra motor with ancilleries (I've seen them for sale) and drop it into an 05/6/7 ?
It's essentially wiring harness and OBC right [?] This is a mod I've been seriously considering given that the 32 valve is such a superior motor in every way.
5th Gear Member
Joined: Sep 2006
Posts: 3,401
RE: 4.6 4 valve?
Hmmm, you could be right at that. I've seen crate Terminator motors (Complete with blower and ancilleries) for around $7.5
I guess you could build a pretty strong 3v for that. It'd never be a 32v though [8D]
I guess you could build a pretty strong 3v for that. It'd never be a 32v though [8D]
2nd Gear Member
Joined: Nov 2006
Posts: 191
From: Long Island
RE: 4.6 4 valve?
ORIGINAL: marcuskeeler
Hmmm, you could be right at that. I've seen crate Terminator motors (Complete with blower and ancilleries) for around $7.5
I guess you could build a pretty strong 3v for that. It'd never be a 32v though [8D]
Hmmm, you could be right at that. I've seen crate Terminator motors (Complete with blower and ancilleries) for around $7.5
I guess you could build a pretty strong 3v for that. It'd never be a 32v though [8D]
5th Gear Member
Joined: Jul 2006
Posts: 4,491
From: New Orleans
RE: 4.6 4 valve?
ORIGINAL: 05gtdriver
The '02 is an aluminum block,high compression engine, the '03/'04 block is a cast iron block, with low compression pistons because it's designed for a supercharger(8.5:1 C/R). Remember too, the Drive By Wire on the S197s must be converted to a throttle cable to work with the earlier modular engines. Unless you can get a crate engine for under $5K, it would be wiser to have someone like Livernois build a forged, stroker 3V for around $5K. Just my opinion.........
ORIGINAL: marcuskeeler
OK, to take this further..... (The thread, not the flaming)
How much work would it be to take a crate 32 valve 2002/3/4 Cobra motor with ancilleries (I've seen them for sale) and drop it into an 05/6/7 ?
It's essentially wiring harness and OBC right [?] This is a mod I've been seriously considering given that the 32 valve is such a superior motor in every way.
OK, to take this further..... (The thread, not the flaming)
How much work would it be to take a crate 32 valve 2002/3/4 Cobra motor with ancilleries (I've seen them for sale) and drop it into an 05/6/7 ?
It's essentially wiring harness and OBC right [?] This is a mod I've been seriously considering given that the 32 valve is such a superior motor in every way.
Thread
Thread Starter
Forum
Replies
Last Post
