PI Swap, where to place second temp sensor on intake HELP ASAP
#1
PI Swap, where to place second temp sensor on intake HELP ASAP
So where can I place the second temperature sensor. Or can I just splice the wires and attached both sensor wires to the one sensor?
#2
RE: PI Swap, where to place second temp sensor on intake HELP ASAP
one of them is the sending unit for your gauge and the other is for the computer i believe. if theres only one port on the intake manifold go to the autoparts store and get a t.
#4
RE: PI Swap, where to place second temp sensor on intake HELP ASAP
My heads have a sensor on the inside of the driver side head that i just plugged into. That is another option if you don't feel like taping it or buying a new cross over.
#5
RE: PI Swap, where to place second temp sensor on intake HELP ASAP
It is a 3/8 pipe thread. I just did a complete PI swap and found this out the hard way. there should be a spot that looks like it would hold another sensor left of the thermostat.
#6
RE: PI Swap, where to place second temp sensor on intake HELP ASAP
There is a spot on the back of your block. Thats where i put mine. it is 3/8 pipe thread to. I pulled the wire from the harness and put it back there.
Thread
Thread Starter
Forum
Replies
Last Post
Gary Ugarek
4.6L (1996-2004 Modular) Mustang
8
08-26-2015 08:41 AM