Camshafts...?
#1
Camshafts...?
so i got my mind set on some Crower stage II cams the specs are:
in-559
ex-570
in-268 deg
ex-272 deg
now it says valve springs are required. im fine with that... but ive been getting mixed information about "notching" the pistons. do i need to? how/where do i do that? the motor is stock, i have a sniper tune (getting warrentyed right now) so i can tune it afterwards. i also know i will have to raise the rear-end gears to atleast 3.73's which i am fine with, i was going to do that anyways.
in-559
ex-570
in-268 deg
ex-272 deg
now it says valve springs are required. im fine with that... but ive been getting mixed information about "notching" the pistons. do i need to? how/where do i do that? the motor is stock, i have a sniper tune (getting warrentyed right now) so i can tune it afterwards. i also know i will have to raise the rear-end gears to atleast 3.73's which i am fine with, i was going to do that anyways.
#2
RE: Camshafts...?
your from rochester... nice.. buffalo here
i have comp cams
550 lift and they are running fine for now...need a tune bad
http://youtube.com/watch?v=Kt3BTp3zHNA
i have comp cams
550 lift and they are running fine for now...need a tune bad
http://youtube.com/watch?v=Kt3BTp3zHNA
#4
RE: Camshafts...?
degree the with the timing tool from ford?
that modualr timing kit from ford like this http://www.fordracingparts.com/parts...tKeyField=8246
that modualr timing kit from ford like this http://www.fordracingparts.com/parts...tKeyField=8246
Thread
Thread Starter
Forum
Replies
Last Post