Coil-Overs
#12
RE: Coil-Overs
Alrighty, I put the C/C plates on today with a 1/2 inch spacer and voila, no noise while turning at any speed.
I then took it to ford and had them align the car.
I then drove over the same bumps that I bottomed out on yesterday and only bottomed out on one of them and it was much much less severe. But I did raise the car just a little bit as well. However the car is very driveable now becuase it takes a heck of a bump for the car to bottom out.
Thanks everyone!
I then took it to ford and had them align the car.
I then drove over the same bumps that I bottomed out on yesterday and only bottomed out on one of them and it was much much less severe. But I did raise the car just a little bit as well. However the car is very driveable now becuase it takes a heck of a bump for the car to bottom out.
Thanks everyone!
#13
RE: Coil-Overs
ORIGINAL: mustang289
Alrighty, I put the C/C plates on today with a 1/2 inch spacer and voila, no noise while turning at any speed.
I then took it to ford and had them align the car.
I then drove over the same bumps that I bottomed out on yesterday and only bottomed out on one of them and it was much much less severe. But I did raise the car just a little bit as well. However the car is very driveable now becuase it takes a heck of a bump for the car to bottom out.
Thanks everyone!
Alrighty, I put the C/C plates on today with a 1/2 inch spacer and voila, no noise while turning at any speed.
I then took it to ford and had them align the car.
I then drove over the same bumps that I bottomed out on yesterday and only bottomed out on one of them and it was much much less severe. But I did raise the car just a little bit as well. However the car is very driveable now becuase it takes a heck of a bump for the car to bottom out.
Thanks everyone!
#16
RE: Coil-Overs
ORIGINAL: Aereon
lols, had me excited, cause thats the thickness I wanted.
ORIGINAL: mustang289
Thats just photoshopped, But I will be painting them in the near future!
Thats just photoshopped, But I will be painting them in the near future!
I am painting my 3 inch cowl hood right now, then in a month or so I will paint the stripes
Thread
Thread Starter
Forum
Replies
Last Post
CrazyCobraSpeed
5.0L (1979-1995) Mustang
11
01-24-2007 12:41 AM
GhostPony
GT S197 General Discussion
2
04-14-2006 11:05 PM