01GT4.6

cool thanks. I think are cars are the same height in the front, mine might be lower in the back but that shouldn't effect the cutouts when they are that far up. Did you ever scrape elsewhere before the cutouts? My h-pipe scrapes at the back end (where the h meets the catback) but that end sits lower than the front end. Thanks again.

02StangGuy

srry to interupt in my own post but do the cutouts have to be welded on? i have a slp catted x so could i remove my cats and bolt up the cutouts?

01GT4.6

yes you can weld them, mine come with a flang in case I didn't want to weld them. I'll probably just weld them in. I'm not sure if they are long enough to cover the distance of a cat conv, but you may be able to with some piping.

GhostRider02GT

I have those same cut outs, sounds like crap, I have a vid in my sig.

tmas99

02stangguy.... hey if you want i'll buy you a off road x and trade you with your x pipe that way you dont ruin a good x pipe? but you said your cats are gutted? i want a catted x pipe.... i dont think it's worth all the troubles i.e. inspection, cops, mil elminators blah blah blah... but that is just me

scfd524

Dude I think you should break open the bank and throw these on.

http://www.quicktimeperformance.com/QTEC/index.php

Then you can roll up to some ricer, flip the switch, give em a taste of V8 then close them before you get pulled over for noise..lol.

H0SS302

lol......"75HP gain on a Turbo Honda "

GhostRider02GT

fat chance, I bought some, PITA to find a spot to mount em, that DC motor is HUGE, I ended up selling them on ebay. There is just no room for that gigantic motor down there