Quick Driveshaft Question
08-07-2007, 10:03 PM
#1
Quick Driveshaft Question
Allright I have a quick question....
I have some Roush rear springs installed on my car. They lower the rear end to an almost level position. The instructions said approximate 1" lower. I want to install a PSI Performance 4" aluminum one-piece driveshaft on my car that a buddy of mine has installed on his car currently. He is going to the H&R Supersports and he knows he will not be able to use the driveshaft while going that low. The question is... will I still be able to use the aluminum driveshaftwith my Roush springs if I were to buy it from him?
I have some Roush rear springs installed on my car. They lower the rear end to an almost level position. The instructions said approximate 1" lower. I want to install a PSI Performance 4" aluminum one-piece driveshaft on my car that a buddy of mine has installed on his car currently. He is going to the H&R Supersports and he knows he will not be able to use the driveshaft while going that low. The question is... will I still be able to use the aluminum driveshaftwith my Roush springs if I were to buy it from him?
Thread
Thread Starter
Forum
Replies
Last Post
Luke9222
4.6L General Discussion
19
10-22-2015 11:55 PM