IAT sensor relocation
#11
hi guys I have just been told about this AIT relocation and am going to do it but as my blower and manifold is on the car I really would rather not pull the blower but will if it is benifical I am considering putting it in the pre drilled bung on the manifold on the top on the passenger side does it make that much of a difference in the back opposed to there? Vapor Trials I see that is where you put yours no issues ever? and Chris Rose what do you think any information would be greatly appreciated thank you very much everyone as I am a new member
#12
Following for the same information. I don't really want to pull the blower until I am ready to rebuild the block (last next year most likely)
But I would like to relocate IAT. Thanks ahead of time
08 GT w/ 550HO Kit
But I would like to relocate IAT. Thanks ahead of time
08 GT w/ 550HO Kit
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
12-27-2021 08:09 PM
01, 3s2z14s411jza, brenspeed, centri, fuel, gt500, iat, installing, instructions, mustang, pigtail, rails, reloaction, relocation, sensor, whipple, wpt322