Throw out Bearing

Reply Subscribe

Thread Tools

Search this Thread

06-21-2006, 11:14 PM

onetrickpony

3rd Gear Member

Thread Starter

Join Date: May 2006

Location:

Posts: 538

Throw out Bearing

How does the throw out bearing go back on the clutch fork? Does it go under the two clips or does it go on top of them?

06-21-2006, 11:28 PM

Boss_Hotrod

5th Gear Member

Join Date: Apr 2006

Location: NC

Posts: 2,166

RE: Throw out Bearing

Man thing to do is just fart around with it. I think it only goes one way. Just have teh flat disc loking surface facing toward the springs.

06-21-2006, 11:49 PM

GaryBisiniere

3rd Gear Member

Join Date: Mar 2006

Location:

Posts: 763

RE: Throw out Bearing

where does the pilot bearing go?

06-21-2006, 11:58 PM

Boss_Hotrod

5th Gear Member

Join Date: Apr 2006

Location: NC

Posts: 2,166

RE: Throw out Bearing

It goes ino the crank. Its the little bearing thats right in the center. You have to have a slide hammer to get it out.

06-22-2006, 04:04 AM

94RoadRacerGT

2nd Gear Member

Join Date: Jun 2006

Location: Santa Clarita, CA

Posts: 332

RE: Throw out Bearing

Unless its like mine. Once we got the tranny out there was a tiny ring on the end of the out put shaft. Well when we got the flywheel off the cast around the bearing was cracked in half and the needle bearings were either dust or broken in half. No slide hammer needed. Guess I over drove it a bit LOL.