Getting code for MAF
4th Gear Member
Joined: Feb 2006
Posts: 1,375
From: Seattle, WA
RE: Getting code for MAF
What is contact cleaner?
I use brake cleaner because it will dry without leaving ANY residue behind.
That may be the problem.
Did you happen to oil your K&N at the same time?
Or you could have a problem with the mas.
Testing procedures should be covered in either Chiltons or Haynes manuals?
By the way...
I don't recommend using the Q-tips as it is fairly easy to mess up the wires with too much pressure. If using Brake cleaner it is not necessarry to scrub the wire clean, as the solvent is rather strong.
jason
I use brake cleaner because it will dry without leaving ANY residue behind.
That may be the problem.
Did you happen to oil your K&N at the same time?
Or you could have a problem with the mas.
Testing procedures should be covered in either Chiltons or Haynes manuals?
By the way...
I don't recommend using the Q-tips as it is fairly easy to mess up the wires with too much pressure. If using Brake cleaner it is not necessarry to scrub the wire clean, as the solvent is rather strong.
jason
5th Gear Member
Joined: Jan 2006
Posts: 3,926
From: Puerto Rico
RE: Getting code for MAF
Check the procedure......
Courtesy of http://www.my5oh.com/forum/viewtopic.php?t=207 (MAF Codes 26/56/66 Troubleshooting
Courtesy of http://www.my5oh.com/forum/viewtopic.php?t=207 (MAF Codes 26/56/66 Troubleshooting
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
Dec 27, 2021 08:09 PM
lincolnshibuya
V6 (1994-2004) Mustangs
9
Dec 8, 2015 04:37 PM
