OTG

just picked up 351 cast irion heads fully ported with 1.6 roller rockers and under drive pullys. have 87 gt with 85 stock moter. runing 14.423 1/4 on street tires, good year m/s.
bbk equl leagth 2.5 mac h pipe, manaflo cat back. 3.55 with aburn 31spline axles, eibok lowering front, rear.
my qustion is, is it a good idea to throw these on with the stock intake.
sorry about this, but its yes it fule injected 85 long block.

FordMustangXBA

That stuff will be fine with the 351.

OTG

thanks i was worried that i might not have enough intake for it. how ever i am looking to
get the new bbk intake for my set up.
went to the trake yesterday to run those numbers.
could have run beter but was not alowed to use nitros becouse i didnt have over flow tube
on the bottle. also no sliks couse no drive shavt loop.

FordMustangXBA

That isn't actually too bad for your setup...You could get it down a bit though...What was your 60ft? 5-spd or Auto?

OTG

6o foot 2.2 spining 1st and 2nd. power shift all gears coming top of third at red line.
my last run last night i cheated and said scew this, juced it in third gear at 14.4 at 103mph.

OTG

5 speed