Anderson-Vortech Mondo intake?
#1
Anderson-Vortech Mondo intake?
Anderson-Vortech Mondo box intake.
anyone know anything about these box uppers?
thinking about getting one.
http://www.andersonfordmotorsport.co...#newmondoupper
anyone know anything about these box uppers?
thinking about getting one.
http://www.andersonfordmotorsport.co...#newmondoupper
#3
RE: Anderson-Vortech Mondo intake?
i would say something but i don't have any experience with this kind of intake so I kept my moutch shut. hopefully FullAuto, Fordstroker or jd1969 will see this and help you out if not PM them
#4
RE: Anderson-Vortech Mondo intake?
I found an artcl on "box uppers" seems like its a good box upper.
http://www.mustang50magazine.com/tec..._intakes_test/
My standard Trickflow R upper was only good for 440hp in that artcl
and thats about what my engine made last time on the dynojet.
The Mondo box upper on TFS R lower was good for 470hp, which is what my engine is capable of from engine dyno.
Think I've figured out that with a 90mm Lightning MAF, 90mm TB,
4" Anderson power pipe intake, 32lbs injctrs and good Box upper along with the 1 3/4 LT's
I just added, I should be able to make same hp as a carb set-up, since I will have zero
inlet restriction from any EFI stuff or non needed long runner upper intake. ( low end torque is not a problem )
http://www.mustang50magazine.com/tec..._intakes_test/
My standard Trickflow R upper was only good for 440hp in that artcl
and thats about what my engine made last time on the dynojet.
The Mondo box upper on TFS R lower was good for 470hp, which is what my engine is capable of from engine dyno.
Think I've figured out that with a 90mm Lightning MAF, 90mm TB,
4" Anderson power pipe intake, 32lbs injctrs and good Box upper along with the 1 3/4 LT's
I just added, I should be able to make same hp as a carb set-up, since I will have zero
inlet restriction from any EFI stuff or non needed long runner upper intake. ( low end torque is not a problem )
#6
RE: Anderson-Vortech Mondo intake?
I had BBK shorty swap headers and it made 350rwhp at 5,200
I just put on BBK 1 3/4 longtubes and will be getting that intake upgrade stuff
Hope to see 370-380rwhp at 6,000 rpm.
I like that Mondo box alot too, cause it cants the TB down at an angle
and will solve all kinds of hood to CAI fitment issues I've been trying to figure out.
I just put on BBK 1 3/4 longtubes and will be getting that intake upgrade stuff
Hope to see 370-380rwhp at 6,000 rpm.
I like that Mondo box alot too, cause it cants the TB down at an angle
and will solve all kinds of hood to CAI fitment issues I've been trying to figure out.
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
12-27-2021 08:09 PM
daltron
5.0L GT S550 Tech
17
04-28-2016 08:10 PM
bradleyb
Classic Mustangs (Tech)
3
11-27-2015 07:50 PM