need wiring help
Thread Starter
Joined: Nov 2008
Posts: 1
From: alabama
need wiring help
i bought a ****** wagon with a speed density 5.0 in it.whoever put it in
put the ox sensers in the exhaust and just left the 3 wires hanging there on
each side.i can't find any wires to hook them up.he must of cut them off
and retaped the harness.does anyone know the color code for the wires
in the harness.i have 2 white and 1 black on the senser so i figure
1 is hot, 1 is ground, and 1 goes to the computor .the motor runs good
but it sure sucks up the gas. thanks
put the ox sensers in the exhaust and just left the 3 wires hanging there on
each side.i can't find any wires to hook them up.he must of cut them off
and retaped the harness.does anyone know the color code for the wires
in the harness.i have 2 white and 1 black on the senser so i figure
1 is hot, 1 is ground, and 1 goes to the computor .the motor runs good
but it sure sucks up the gas. thanks
4th Gear Member
Joined: Oct 2008
Posts: 1,107
From: Virginia
It probably would suck the gas without o2 sensors. This site has alot of wirins schematics. http://www.veryuseful.com/mustang/tech/engine/#Diagrams
Here is the one with the oxygen senor. http://www.veryuseful.com/mustang/te...gO2Harness.gif
Here is the one with the oxygen senor. http://www.veryuseful.com/mustang/te...gO2Harness.gif
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
Dec 27, 2021 08:09 PM
Matt's 95 Stang
5.0L (1979-1995) Mustang
2
Oct 5, 2015 07:16 AM
