Torque Boxes
#1
Torque Boxes
How do they look? Are they acceptable? What should I do with them? I'm having SFCs installed and would like to know if I should address the torque boxes in any way as well - since the shop will be under there. Thanks!
Passenger side:
Drivers side:
Passenger side:
Drivers side:
#2
Yours are still intact on the lower side but I am not seeing any pics of the upper ones. Its well worth the money to just go ahead and get the reinforcments and put them on. I just ordered mine today as a matter of fact. $79.90 shipped on ebay. 11 gauge steel with 8.8 grade hardware. I will weld mine in and add a few beads to the factory boxes but from what I understand the upper torque boxes are the weak link. Especially if you have poly bushings in the axle and in the U/L control arms because thats causes alot of excess strain.
#3
weld your seams shut or or stitch weld them. driver side is the worst of the two IMO but they look fine. get pictures of your uppers though.
and +1^^ to the above, always a good idea to reinforce them if you plan on doing a lot of beating on it.
and +1^^ to the above, always a good idea to reinforce them if you plan on doing a lot of beating on it.
#5
Crap - I didn't think to take pictures of the uppers I'll get some updated shots when the car is on a lift next week.
I'm still learning with this car. I only drove it twice and one of those times was in my driveway...lol.
Thanks for your help guys - it's much appreciated!
I'm still learning with this car. I only drove it twice and one of those times was in my driveway...lol.
Thanks for your help guys - it's much appreciated!
Last edited by mAnYsTyLeS; 04-16-2009 at 11:03 AM.
#8
Thanks! I'm not positive about how many miles the car has on it. I'm pretty sure the body has over 100,000 miles and the 351W that was swapped in has about 60 - 70,000 miles on it.
The car was a red on red 4 cylinder and the previous owner restored it to a Porsche silver exterior with a dyed/painted black interior. For a 22 year old car, it's in pretty good shape.
Now I just have to learn how to work a manual transmission...
Last edited by mAnYsTyLeS; 04-17-2009 at 01:54 PM.
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
12-27-2021 08:09 PM
daltron
5.0L GT S550 Tech
17
04-28-2016 08:10 PM