big problem help!!
#1
big problem help!!
i was installing my new lower intake manifold and its all sealed and bolted down and i dropped a very little piece of plastic in one of the ports. now what do i do. do i have to unbolt the whole thing and take it out or is there another way around this. thanks
#4
RE: big problem help!!
It's unlikely that a sliver of plasic would get trapped in the intake or exhaust valve seat. Just to be sure, I'd break out the shop vac, and tape a piece of mesh dish scrubber over the nozzle and suck it out.
Thread
Thread Starter
Forum
Replies
Last Post
Luke9222
4.6L General Discussion
19
10-22-2015 11:55 PM
musnicki
Classic Mustang General Discussion
8
09-23-2015 07:11 AM