car starts but dies right after
#1
car starts but dies right after
I took off my upper intake manifold off to change the valve cover gaskets and when i put everything back together the car started right up but it dies right after it finishes starting up
Any help is well appreciated i need it to be fixed asap
Any help is well appreciated i need it to be fixed asap
#3
There all hooked up but when I was pulling the vacuum line off of the fuel pressure regulator that goes into the upper intake it snapped so I tried to use a different hose on it but still no luck. And what's weird is the antifreeze is over the full hot mark on the tank and I never added anything
#4
it sounds like a vacuum leak to me too. but maybe more or less around the intake itself. check to see of the intake gasket was messed up when you re-bolted everything back together. or that all the plugs were plugged back up/ could be something small and overlooked like a tps sensor.
#5
I did the same thing you did and the Fuel PVC line was disconnected. This goes on the lower intake toward the firewall. make sure you bolted your upper and lower intake to the proper specs in and sequence. torque specs vary depending on your vehicle year.
Thread
Thread Starter
Forum
Replies
Last Post
ShaneB26154
4.6L (1996-2004 Modular) Mustang
35
03-04-2021 04:05 AM
Soldier GT
4.6L (1996-2004 Modular) Mustang
12
08-20-2015 09:42 AM