Acceptable Belt Configuration?
#1
Acceptable Belt Configuration?
I had to ditch my power steering pump, this was the only belt configuration I could figure out with the remaining parts. Does this look OK?
(Previously the alternator was driven by just the crank, and the other belt went crank-water pump- power steering).
(Previously the alternator was driven by just the crank, and the other belt went crank-water pump- power steering).
#2
RE: Acceptable Belt Configuration?
Also, what are these indentations on the crank pulley (red arrows)?
I doubt I installed it the same way it was, just wondering if they're for balancing or something weird...
I doubt I installed it the same way it was, just wondering if they're for balancing or something weird...
#4
RE: Acceptable Belt Configuration?
and I think the holes are slightly off on the pully so it can only be put on one way, like the flexplate. Maybe not though, in any case it shouldn't matter the direction.
pullys look good!
pullys look good!
Thread
Thread Starter
Forum
Replies
Last Post
autoedit
General Tech
0
09-27-2015 06:37 PM
mrmrultimate
Texas Regional Chapter
2
09-10-2015 09:43 AM