Classic Mustangs (Tech) Technical discussions about the Mustangs of yester-year.

Engine won't run

Thread Tools
 
Search this Thread
 
Old Sep 2, 2008 | 01:21 PM
  #1  
Mindys67's Avatar
Mindys67
Thread Starter
 
Joined: Oct 2007
Posts: 12
From:
Default Engine won't run

All of a sudden, our '67 (289) won't run. Engine fires when turn the key, then immediately dies. Occasionally, will run for a few seconds at high rpm if hold gas pedal to the floor, but then shuts down.

Seems to be getting gas and spark.

Any ideas?

Help!
Old Sep 2, 2008 | 01:34 PM
  #2  
blue66mustang's Avatar
blue66mustang
2nd Gear Member
 
Joined: May 2007
Posts: 332
From: Illinois
Default

Check if the coil is getting power when the key is in the "run" position. Sometimes the coil is powered with 12 Volts while cranking (wire runs from the starter relay) and then switches to the ballast after it starts.

Other than that check the fuel filter and float bowl for debris.
Old Sep 2, 2008 | 01:46 PM
  #3  
boogerschnot's Avatar
boogerschnot
5th Gear Member
 
Joined: Feb 2007
Posts: 2,688
From: Ramona, CA
Default

Also check your timing. Did you tighten the hold down bolt? Mine gave me that problem,, it would start to stumble and then die out.. I had forgotten to tighten it down..
Old Sep 3, 2008 | 05:44 AM
  #4  
kalli's Avatar
kalli
6th Gear Member
 
Joined: Oct 2006
Posts: 6,417
From: Cork, Ireland
Default

blue66mustang has it bang on I believe.
On that thought just run a wire from battery+ to coil+
See if that solves your problem.

BUT BE WARNED: if this helps it's only to isolate the issue. do NOT run your car like this. You'll fry your coil when this is on for too long and car not running.
Just put it on. give it a try. Then remove it again. let us know the result

Kalli
Old Sep 3, 2008 | 04:49 PM
  #5  
Mindys67's Avatar
Mindys67
Thread Starter
 
Joined: Oct 2007
Posts: 12
From:
Default

Definitely something in the ignition circuit. Sometimes getting power to the coil, sometimes not. Wiggling wires, can sometimes get it to run for awhile. Time to start tracing wires.
THanks for the suggestions.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
djbigskrilla
2005-2014 Mustangs
24
Sep 20, 2022 01:04 AM
Gary Ugarek
4.6L (1996-2004 Modular) Mustang
63
Dec 11, 2015 02:01 PM
ShaneB26154
New Member Area
5
Aug 28, 2015 04:47 PM
KEM Motorworks
5.0L (1979-1995) Mustang
20
Aug 14, 2015 10:13 PM
Pain.
5.0L (1979-1995) Mustang
1
Aug 7, 2015 10:48 PM




All times are GMT -5. The time now is 07:43 PM.