abs pump
#2
RE: abs pump
You can start by unplugging the harness that controls your abs and traction control. Its located front right of the engine bay. There is a large block with 6 hard lines (i think) coming off of it. Closest to the fender well, you'll see a large gray U shaped clip. Pull that toward the engine, and then pull the connector straight up. Check for corrosion on the pins and the connector. Water likes to sit in there and corrode the connections. That should give you a good starting point.... Good Luck.
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
12-27-2021 08:09 PM
mrappe
V6 (1994-2004) Mustangs
0
09-26-2015 10:16 AM