Throttle bodies
#11
RE: Throttle bodies
I have an 01 Cobra with a BBK twin bore 65mm throttle body. I can honestly say that I am not happy with it. At this point it sticks from time to time. It actually sticks open and my car will rev up to about 2300 rpm when I pull up to a light and push in the clutch. I have played with it for a while but can't figure it out. Any suggestions, (other than just forking over the money for an accufab) which I may end up doing?
#13
RE: Throttle bodies
That has been the major consensus.....I just can't see spending another almost $400 when I already have a bigger than stock bore. I just need to pull this thing off when I am not too lazy and figure out why it keeps sticking. I have heard of other problems like the flaps closing too tight becuase of vacuum but their is a set screw for that. When I took the car to AMP Performance they told me it was a BBK as soon as I told them the problem but their only fix was to buy an Accufab. There has to be a way.
Thread
Thread Starter
Forum
Replies
Last Post