Just installed a 2.2L KenneBell and I am running 20 psi what kind of power do you think it is going to make on blower? Then I am adding a 100 wet shot to that and see how that goes

 

the 2.2 is better than the new ones .. and you can actually hear it... I predict about 600-650 rwhp on blower - 750 or on spray.. that shot is going to be killer sc'd ... you might see 800 tq

 

then again maybe not... that high - but pretty darn close id guess... watch those pistons

 

630rwhp is my guess

 

600hp on s/c 725 on spray

 

running the 2.2 at 20 psi is maxing out ur supercharger, which creates very high intake temps, especially if u dont have any cooling mods, and spray on top of that?? i wouldn't expect ur pistons to last even a year on that set up?? do u atleast got a decent set of headers? what MAF r u running? what size injectors, what fuel pump? i forsee mr. detonation paying u a visit very shortly...... [:@]

 

I though the 2.2's maxed around 25psi? I would say you make low 600's on blower.

 

no, they max out at 20 psi +/-

 

No it is not 20 psi is not max on a 2.2 kennebell around 25 psi it will hold just fine and for the injectors I have 60lb and the fuel pumps I have ford gt supercar pumps with a boostapump and I am running the mafia there will be no problems with the motor I can promise u that!!!

 

okay, but don't make me that promise too fast. and i guarantee u that u will never get 25 psi out of a 2.2 kb. maybe that is what u have read, but i doubt that u have the experience that i do. the 2.2 cannot boost 25 psi. Again, what cooling mods do u have?? Guarantee u the motor will not last long like that.

predictions:

cylinder #7 will loose compression from damaged piston caused by localized overheating or detonation in that cylinder