94 Mustang GT CAM
#3
RE: 94 Mustang GT CAM
low 5.0 is right, if you are thinking of getting a cam start first by updragind your heads. trickflow sell a kit (heads, cam, timing chain, upper and lower intake manifold and I am not sure but they also come with r/r, rods and gaskets.
wwwtrickflow.com
www.pacificaperformance.com ask for Dan he can help you out.
Good luck
wwwtrickflow.com
www.pacificaperformance.com ask for Dan he can help you out.
Good luck
#4
RE: 94 Mustang GT CAM
There is an article in March issue of 5.0 Mustang and Super Fords magazine about Cranes Power Max 2020 camshaft installed in a bone stock virgin 93 GT convertible with automatic trans. The cam has a 0.530/0.530 intake/exaust lift with 0.208/0.216 duration at 0.050 and they were running 1.6 ratio rockers. The gains on Hp and Torque started going down hill at 4,058 RPMs on the Dyno. This isn't to bad, having all the emission systems intact and all "choked up" with stock heads, intake, and no headers.
Thread
Thread Starter
Forum
Replies
Last Post