infantrycav

so i retimed my car a few days ago after putting my hpipe in, it drove great especially with no leak at the header collector anymore, i had a random vehicle inspection when pulling into post today and noticed my spout connector not there, I guess i forgot about it and it fell off the rad or something...stupid stupid stupid! It runs better, it feels a bit sluggish but better than before at take off but once the rpms rise its fine, so I dont know how it runs so well with no timing advance but hopefully it will be a lot better when i reconnect it.

I can't find any quotes on-line and am afraid of the raping I'll get at ford... can i use a blade fuse or something of the sort. I know I could cut the connector and use spade connectors but would rather not go that route.

FiveLiterRiceEater

you could probably use a jumper wire

AdderMk2

im going to the local junk yard tomorrow... if i can find one ill send it out to ya.

ill hit ya with a PM if i find one

infantrycav

thanks dude much apprec., I'll try a blade fuse or just use a jumper for now i guess. i just cant believe how wel it ran w/o it.

AdderMk2

yea... a short jumper wire and electrical tape will do good for you