So i bit the bullet and bought some afr 185's on ebay. good deal for 1100 brand new. Im gonna purchase an airgap intake and probably switch to a 650 demon carb, no clue which one. Will my 600 edelbrock be ok for a lil while? i think 750 will be to big with my motor. now i need to start looking at a cam to match up with the whole setup. any suggestions?

 

Congratulations! Damn, I have a brand damn new air gap I need to return to Schucks( if they'll let me, it's been since Sept). Too bad you didn't live closer, I'd sell it to your for $199.00
[align=left] [/align]

 

pretty good deal i bought some afr165 rockers cam pushrods and arp bolts for 1200$

 

Call comp cams they can set you up. Thats the only way I do any motor now.

 

i'd say a 600cfm carb should be ok, i woul;dn't upgrade without knowing how that runs ...
keep it and see how it goes I'd say

 

damn...if i have a roller block do i still need to buy new roller rockers for these heads?

 

you dont have to have rollers but its nice to have them, since most of the afr heads use studs to mount the rocker you will at least need some for non rail heads, your factory rockers might work if they are non rail. you can pick up a decent set of rollers for about150$