brake/fuel line
#1
brake/fuel line
I'm in the process of running the fuel, and have questions regarding the clip locations.
1. the "shared" clips located on the tunnel, are they supposed to hold both the brake/fuel line or alternate between the two.
2. is there supposed to be a clip on the outside of the frame holding the fuel line just before it enters the engine bay to the pump (289)
3. is there supposed to be 1 or 2 clips holding the fuel near the shock
The diagram I have is not very clear, so if this was covered could someone post the link or a diagram of where everything is located.
1. the "shared" clips located on the tunnel, are they supposed to hold both the brake/fuel line or alternate between the two.
2. is there supposed to be a clip on the outside of the frame holding the fuel line just before it enters the engine bay to the pump (289)
3. is there supposed to be 1 or 2 clips holding the fuel near the shock
The diagram I have is not very clear, so if this was covered could someone post the link or a diagram of where everything is located.
#2
The clips hold both lines.
Yes there is supposed to be a clip on the outside of the frame for the fuel line before in enters the engine bay.
I would have to climb under mine to answer your other questions. If no one else responds, I'll try to do that for you.
What part of Texas are you in? I'm in central.
Yes there is supposed to be a clip on the outside of the frame for the fuel line before in enters the engine bay.
I would have to climb under mine to answer your other questions. If no one else responds, I'll try to do that for you.
What part of Texas are you in? I'm in central.
Last edited by tx65coupe; 06-24-2010 at 01:44 AM.
#3
The clips hold both lines.
Yes there is supposed to be a clip on the outside of the frame for the fuel line before in enters the engine bay.
I would have to climb under mine to answer your other questions. If no one else responds, I'll try to do that for you.
What part of Texas are you in? I'm in central.
Yes there is supposed to be a clip on the outside of the frame for the fuel line before in enters the engine bay.
I would have to climb under mine to answer your other questions. If no one else responds, I'll try to do that for you.
What part of Texas are you in? I'm in central.
I'm in the DFW area.
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
12-27-2021 08:09 PM
Matt's 95 Stang
5.0L (1979-1995) Mustang
2
10-05-2015 07:16 AM
AMAlexLazarus
AmericanMuscle.com
0
10-01-2015 09:21 AM